Fishing on the Donk
Fishing on the Donk today enjoy great popularity among anglers. This technology combines the simplicity, reasonable cost and high efficiency. In this article we will tell you about Donna and tackle, types, lures and the technology of fishing.
Bottom fishing has been known since antiquity and has served the fishermen faithfully for many hundreds of years. The main purpose of this gear is to fishing for bigger fish that feed from the bottom.
- 1 Modern tackle
- 2 fishing Line tackle
- 3 Selection of sinkers
- 4 Choice leashes
- 5 Selectable bait
- 6 fishing on the Donk
- 7 the Use of donok with rubber shock absorbers
- 8 the Spinning donkey
- 9 donkey with a trough
- 10 Spring
- 11 Feeder
- 12 Signaller of bite for donkey
- 12.1 Bells
- 12.2 Electronic bite alarm
- 12.3 Bells
- 12.4 the Rod as a bite indicator
- 13 Snap donkey
- 13.1 the easiest option
- 13.2 Snap-in with spring
- 14 Videos “Fishing on the Donk”
Design bottom gear extremely easy. The fishing line is wound on a spool or reel is large in size sinker above which is located a few leashes with the bait.
The presence of large sinkers are required for long casts and hold the lure motionless on the bottom even in strong currents of the river.
Fishing line tackle
When casting for the bottom gear have a large load, so it is recommended to choose a thick enough line. The minimum diameter is 0.35 mm. As fishing tackle involves first large size trophies, use a thick and strong fishing line will allow sure to draw out even the largest and strongest fish.
The selection of sinkers
The best form of weights to a fishing line is a teardrop, which allows to provide the greatest long-distance casting. The weight of the load can vary from 30 to 100 grams. It should be noted that the heavy weights are easier to throw, so they are more suitable for fishing in the river. At the same time be aware that the larger the weight of the sinkers, the greater the noise when entering the water it produces. Consequently, cautious fish at long time to leave the fishing spot. So if possible, recommend the use of sinkers weighing 30 – 50 grams.
The main trophy when fishing on the Donk is big fish, so the fisherman should choose the appropriate high quality hooks. Optimum use of the hooks with the effect of samorodnitsky, in some cases, even use large-size counterparts.
Choose the bait
The election of the bait is critical for successful fishing. A particular choice of bait depends on the fish you plan to catch and the particular reservoir. It is also necessary to consider the presence of currents on the fishing spot. Remember that the best bait will be the usual fish food. That is why the use of expensive feeder heads to a remote river or lake will not give the desired effect. The fish just are not used to such nozzle, and will give her a bite.
Try to maximize the use of nozzles. It can be various cereals, peas, grain, dough, or nozzles of an animal origin. The best would be if you use on the ground several leashes of different nozzle. So, you can significantly increase your chances of a catch. Determining a preferred head fish on concrete pond, you will then be able to catch the biggest and the rare trophy fish.
Fishing on the Donk
As a rule, fishermen who fish on the bottom gear, using not one, but several donok. This allows them to take an extensive stretch of coastline, which increases the chances of a catch.
The donkey reel or coil with a small spinning must be carefully mounted on the shore. Because fish can bite sharply and intensely, not fixed one can be just to pull in water. Whenever possible, braid fishing line for the bottom of the driftwood on the shore, or small trees.
Choosing the site for fishing is necessary to give preference to areas without snags and algae. It is also not recommended rocky bottom, which increases the probability of hooks. The best time for angling is considered to be evening, night and morning. It is recommended to set trotlines in the evening and check them in the middle of the night.
In most cases, difficulties with the casting do not arise. You need to swing like a pendulum a heavy load and release the line. Pre-wind the required length of fishing line from the reel and lay it in neat rings. It’s possible, initially you will have to be some difficulties with the casting, but after a little practice you will be able to throw a sinker at 50 meters or more.
The use of donok with rubber shock absorbers
Many anglers when using a donkey faced with the problem of silent reflux. The solution to this problem is the use of special rubber shock absorbers, which allowed quietly to make repeated casts.
The advantages of donok with rubber shock absorbers:
- You can deliver the bait lured in one of your choice.
- Complete silence re-casts.
- The so-called small-game bait.
- There is a possibility of point feeding.
- A large number of leashes on the ground increases the chances of success.
From disadvantages it is only necessary to note the fact that the rubber quickly breaks down and needs to be replaced.
Such a set consists of:
- The safety fishing line cross-section 0.5 mm.
- Heavy sinkers on the foot nylon leash.
- Shock-absorbing elastic bands with a length of about 10 meters.
- The line with the leads to the removal of several meters from each other.
- The basic scaffold with a diameter of 0.35 millimeters.
Possible difficulties you may have only the first casting sinkers. In this case I can recommend you to use the boat which will silently lower the heavy cargo to the desired location of fishing. Don’t forget to tie a heavy sinker foam float that will allow you to get gear when it is open. After fishing, you can arrive in style by boat to the foam float and get your gear.
Before you start fishing, you need to properly prepare the gear. The donkey with the eraser, there are two Swifts, one of which is a fishing line with a rubber band, and a second safety rope. It is necessary to put the reel at a distance from each other at 5 meters. Calculate the required number of coils of fishing line, which you need for accurate casting. To lay the coils of fishing line is required so that when casting began to unwind the upper coils, thus avoiding the likelihood of tangling of the line. Don’t forget about the insurance that otmelivaetsja a few meters larger than the main fishing line with a rubber band.
Remember that to put the fishing line with the bait is required after casting donkey with a rubber band.
The connection is made by means of carabiners, and after fishing carabiner is detachable. You only will be using the insurance to get the cargo out of the water. Keep the snap with the rubber band on a separate reel. To ensure its safety and durability.
The spinning donkey
Original classic Donk was a very manual tackle. However, in consequence of great popularity began to use spinning rods, the reel which was used in fact, instead of the reel.
With minor variations spinning for donkey was called a feeder. This kind of tackle today enjoys great popularity, and allows you to fish a variety of large fish. The popularity of the feeder is due to the simplicity of fishing, availability of equipment and the ability to catch the maximum trophies. At the same time, be aware that the feeder is a fairly specific tackle that in an unknown environment with new lakes and rivers may not give the result. But in those places where anglers often catch on the feeder, its effectiveness is high.
The use of spinning for donkey allows you to simplify the process of throwing bait. In this case, there is no need for expensive coils required for the classical spinning. Note also significantly simplify the process of fish playing. If before, when using the reel all actually had to be done manually, using a spinning rod and reel you can make the best to draw out even the strongest fish. Reduces the risk of a descent of fish from the hook, as you can best pick up line tension when playing a fish.
The coil is wound about 50 meters of fishing line with a thickness of 0.3 meter. Leashes are attached to the main fishing line with a carbine, and a heavy load allows you to easily perform the casts to the maximum possible distance. In total when you buy Chinese coils the total cost of tackle can be a few tens of dollars.
Donkey with a trough
If need long casts, which are practiced during the fishing ground, the fishermen may face the problem of bait fish. How to precisely deliver the bait to the site of an abandoned donkey? In the end, the idea of upgrading gear, which had a small feeder attached with the rifle.
Many anglers have produced a primitive handicraft feeders from small springs. Today, these feeder springs are used effectively when fishing for a trout line.
The main object of fishing on the feeder-springs are white fish. Such fish include bream, bream and carp. In rare cases, with springs caught carp and silver carp. The choice of bait and tips for catching the increasingly depends on the specific characteristics of the reservoir and the preferences of the local fish.
In specialized stores you can find dozens of different models of feeders that vary in their weight and shape. They are designed for different fishing conditions and different purposes. However, they have in common is that the main purpose of feeders is to attract fish.
Very popular these feeders use when fishing the feeder. To make a bird feeder by yourself from a metal wire and lead. You can also purchase ready-made varieties of bird feeders in specialty shops. Their cost is not high, but they are effective and allow you to lure the fish, thereby increasing the chances of success.
Remember that you must use the same bait for bait on the hook. This will allow you to catch even the most careful and large fish.
Signaller of bite for donkey
For many years the most popular bite indicator at the bottom of the rod was an ordinary bell. He was hanging down attached to the main fishing line directly from the reel or fishing rod. I can say that these bells are the best option to tackle without fishing rods.
Electronic bite indicator
With the emergence of new technologies of mechanical bells began to improve. There are special waterproof electronic signaling devices, which are produced when the bite distinctive sound. Also, these detectors were equipped with light indication. The only drawback of these electronic bite detectors is their high cost.
The bells is a rather interesting version of the bite indicator, which is located at the tip of the rod. The only disadvantage of this indicator is the lack of bite in those cases when the fish after taking the bait is angler. In such cases, the bells do not indicate the bite, and the fishing line just sags.
Upgraded versions are bells have a special niche to install the lights. This will allow you to use them for night fishing.
The rod as a bite indicator
There is a possibility of the use of the rod as an indicator. When a big fish bites the tip of the fishing rod starts to bend and shake. At the same time, be aware that such detectors are suitable only for daylight hours, and require the fisherman’s constant attention to the rod.
Today, there are dozens, if not hundreds of different snap-ins for the donkey. All to describe them is simply impossible. Let us consider the most common and reliable versions.
The easiest option
Despite its simplicity snap, this option is perfect for luring the biggest trophy fish. In this case, using only one node, so the strength of the snap-in can not be doubted.
Fasten to a fishing line slip sinker in the form of a teardrop shape or an olive. For fixing the sinkers you need to use a silicone clip. Remember that the stopper must be fixed firmly and rigidly. When casting tackle on the stopper has a significant load, but he needs to keep his position. I can recommend you to use as a reliable stopper soft lead pellet, which is clamped on the line. By the end of the line without a leash tied to the hook. It is also possible snap with the use of a leash, which is attached via a swivel.
Snap-in with spring
With the same success snap donkey with a spring suitable for fishing with rod and hand-cast. Especially effective combined with spring when fishing in lakes and rivers with calm water.
The first option – moving snap donkey with a spring. In our case, model a sliding sinker donkey in the spring. In the spring, easily stuffed a viscous porridge or peas. The choice of bait depends on the species of fish and its particular preferences in your pond.
The advantage of moving the snap-in is that a fish during the bite feels no resistance, which is necessary for catching careful and big fish.
The second version of the snap-on spring set short leashes that are recessed into the bait located in spring. Actually, in this case the bait is used as feed and bait. The second option is perfect for catching bream and carp. In this embodiment, the snap fish pinpoint itself and the angler only needs to pull it out of the water. I can recommend you to use leashes for fishing line braid with a thickness of 0.1 — 0.15 mm.
In that case, if you catch a strong current or deep holes and sharp departure depth, directly in front of the spring it is recommended to install a flat sliding sinkers. Such a flat shape of the lead weight will not allow to demolish it.
Video “Fishing on the Donk”