Overview of spinnerbaits for pike: lure and fishing technique
This lure is quite original snap-in for catching fish, invented in America about a hundred years ago. After a couple of decades of this snap-in is started using the whole world, since it is possible to catch almost any predators in the most severe fishing conditions. The best results this lure demonstrates when fishing for pike.
The name snap is a combination of spinners and lures. There are five components:
- A piece of wire that resembles a yoke.
- The petals, which are located at the top.
- The hook is located at the bottom of the rocker.
- Head of lead.
- The fringe is made of silicone, which hides the hook.
Additional information. Quite a lot of fishermen believe that the bait should be similar to real fish. The strange appearance of not attracted to spinnerbait fish, because it is like no other. But in practice, this snap-in can bring a pretty good catch.
For pike the most important thing in a successful hunt — her vision. When the transaction happens, the lure makes a noise, the petals begin to spin, the skirt creates oscillations, while its diameter is changing, and it does the fish. The movement of the lure irritate the fish, which is why predators attack. With time, the skirt lose its shape, because the predator when attacking it just breaks. This part is quite simple change.
This snap-in is ideal for difficult fishing conditions. A lure without hooks floats through the thick grass and snags, it is in these areas the largest number of pike. Thanks to its unique fixture design:
- Thanks to the rocker hook does not catch on obstacles.
- Sinker attached to the snap-in vertical position to pass areas with grass.
- Each petal pushes the grass, reducing the risk of a hook.
Not to say, this tooling is the most efficient compared to other lures. Many cases when this lure is much better attracted the predator, compared to various lures. For this reason, it is recommended to in its Arsenal to have a few spinnerbaits.
This lure is worth a lot, for this reason, some fishermen have no more than 2 of the snap-ins of this type. But the bait can do it yourself here’s what you need:
- Wire made of steel with a diameter of about a millimeter.
- Sheet stainless steel or brass for petals of 0.1-0.4 mm.
- Hook, the shank must be long.
- Clockwork ring swivel.
- The bait is made of silicone or rubber, which secure the money of them made skirt.
Need form of gypsum, which will be added to the lead head, the same shape for the petals. First made rocker in the middle is a ring for attaching to a fishing line. Then attached the hook, the excess wire is removed, the head is filled with lead. Made petals, holes in them. The petals are mounted on top of the rocker. Wire twisted into a ring. The skirt is attached to the super glue. When the tooling is made independently, you can try to do different sizes and shapes of each part.
If you use uniform wiring, need to know what is suitable for fast fish. At a time when the predator is hungry, slow retrieve attracts the fish. It is desirable to keep the bait near the bottom. Thus, a wave mode is more effective. The wiring should then accelerate, then slow down, so I see better the movement of the skirt.
The spinnerbait is quite original and unusual lure that very well attract a predator. Although the structure of the lure is quite strange, the fish is beautifully reacts. Quite a lot of fishermen have not used this equipment, especially beginners, definitely worth a try. In addition you need to remember is to remember a very important detail — this snap-in, you can catch not only a lot of pike, but is more likely to catch other predators. Bait works well on almost all waters. Of course the price is a little more than different versions of different lures but the bait is worth it, due to a rather good performance.